论坛上下载的PIS-RCTP在低空跑道会消失
本帖最后由 jinson 于 2017-12-1 02:33 编辑重新安装了好几次，都是这样在低空时跑道没有纹路
我将地景库插件全部关掉一个个打开载入后发现，只有在1002BASE这个地景如果载入时跑道会消失
但如果关掉后跑道台湾周边的海域会消失(像下面这张图一样)
貌似这个地景是台湾周边海域的文件，不载入1002BASE海会消失，但载入换跑道消失
请问这是什么问题? 该怎么解决?
是1002BASE地景档损坏吗?
帮你顶一下 你这个情况我咋没碰过。同样PIS-rctp 精细度开得不够高？ 設定要調高只有rctp會這樣？ 这样的问题总会存在的，你分析的还挺准的 没遇到过楼主说的情况呢 bbarry123tw 发表于 2017-12-1 14:19
設定要調高只有rctp會這樣？
是的，只有RCTP會這樣
我裝了挺多機場地景，就只有RCTP會這樣
請問設定從哪裡調整? 記得手冊裡有寫到相關的建議設定，一開始也有這問題，調整後就行了 FSX毛病多多啊 happy549026 发表于 2017-12-3 02:40
記得手冊裡有寫到相關的建議設定，一開始也有這問題，調整後就行了
請問是下面這個部分嗎? 這該從哪邊調整設定?
Frame rates from scenery complexity and autogen settings were averaged at 30fps. This includes moving sliders 100% to the right. Lower settings yielded much higher frames, but our recommendation is Dense to Extreme Dense for exceptional rates. Since the scenery is 15/30cm/pixel photoreal, it is highly recommended that Mesh Resolution be set at 1 meter within FSX Display Settings (slider 100% to the right). Texture Resolution should also be set at 30cm and above (or slider 100% to the right).
Recommended Sea and Road AI Traffic settings:
There are AI boat traffic throughout the coastal waters of the Taoyuan and Dayuan areas. To maintain exceptional level of FPS, it is recommended that leisure boats be set at 30% or less.
AI road traffic should be set at below 25%. ttianshu63 发表于 2017-12-3 21:16
楼主是不是装过VECTOR？
我有装Pilots - FS Global 2018 FTX 地型插件
不过我试过移除后再载入地景，跑道还是一样消失 jinson 发表于 2017-12-3 16:18
請問是下面這個部分嗎? 這該從哪邊調整設定?
Frame rates from scenery complexity and autogen settings ...
對，要把地景的設定調高
页:
[1]