ProSim737 1.48版本
- Generic Com/TCP driver values rounded to the3rd decimal place- Dome light switch support added to ICSoverhead- ProSimDisplay: new option to add the foldername to the title bar- fix to prevent brake pressure to be negative- Fixed RED indicators handled as YELLOW- added Simworld Flight Controls module support - ILS-DME(Navigraph navaid type 8) navaids now correctly handled ifentered in CDU FIX page- Sismo: Fixed servo daughter board not working
- Sismo: Fixed displays outputs(Display daughter board 2)
- new cockpit option to select alignment time (normal - quick)
- Master Dim gate added
- IOS Failures now organized by ATA chapter
- Fixed FDS JetMax radio assignments
- added cache control meta tags to IOS page
- added option to cockpit setup to remove the fading from weather radar sweep
- added option to cockpit setup to remove the interpolation(antialias) from theweather image
- Engine trend vector disapearing when target N1 value reached.
- Speedbrake stow not working below 10kts.
- Retractable landing lights switch not working correctly withCPFlight overhead.
- Simworld ATC panel delay fixed
- Added advanced option to CPFlight driver to disable the gauge data
- Fixed fuel filter failure to trigger an oil filter warning onEICAS
- Scavenge oil filter failure added
- Wiper switches and gates added.
- Wiper switch support added to CPFlight(ICS) and Simworld overhead and ProSimpanel.
- Fixed Side-by-side EICAS showing FF as KG even when unit is LBS
- Fixed Brake accumulator pressure to lock if pressure reaches 0
- Hydraulic system B should be the only pressure supplier to the brakeaccumulator.
- Fixed Pokeys Ethernet not working with poller disabled
- CPFlight advanced option added to reverse the rudder trim gauge
- Added support for FDS CDU v2 alternate layout
- EFIS POS now shows ADIRS and GPS positions on ND
谢谢分享～～～～～～ 连猜戴蒙 勉强能看明白 这个不错，感谢分享 传说中的2D仿真座舱？现在风头不劲啊 这得买硬件才能支持啊。
页:
[1]